Bath faceplate

A panel or screen for the side surface of the bath is installed to give the bath itself a certain design, often being a single whole of the bathroom. Make it yourself is not difficult. After reading the below recommendations, this will make any. The front panel not only gives the bath an aesthetic look, it also plays the function of protecting against moisture at the bottom of the bath, which is difficult to clean, and in some areas under the bath, it is completely impossible to do. Stages of manufacturing. A beautiful decorative panel will be obtained after completing a specific list of works: • determining the type of the front panel; • production of frame base and its installation; • reliable fastening of drywall to the base; • laying the tiles. The panel can be made of 3 types: be solid, with a special recess under the legs and at an angle. Regardless of the option, it should have a revision hatch that will help maintain the bath communications. It can be purchased at stores selling such products or make one yourself.Features of frame bases. Usually the base is wooden or metal. The choice of the frame base material depends on the type of tile. If it is heavy, then the base should be only metal. In the manufacture of metal frame base, a CD profile, a perforated angle, screws for metal, a "seed" screw are needed. For the manufacture of the base of the front panel, we first carry out marking work. Here you will need a plumb line, a square and a pencil. Using elementary knowledge of geometry and the specified tool, we draw the contours of the required structure. Profile, with the help of scissors for metal, cut into the required size. Then we join the obtained parts with the help of metal screws into a single frame. At this stage of work, you need a screwdriver. Then securely fasten the base on all sides with dowels with impact screws and a hammer. To enhance the construction, we mount vertical jumpers.
 The front panel for the bath
A little about fixing moisture-resistant drywall and work, after which you can engage in laying tiles.With the help of a drawing tool and a pencil, directly on the surface of the drywall we apply the contour of the necessary part and with a sharp knife cut off the necessary part. We fix the drywall with metal screws. We use a screwdriver with a special nozzle and limiter, which will help not penetrate deep into the body of drywall. We fix in steps not exceeding 20 mm. In the corners, for durability and ideally flat surface, we mount a perforated corner made of aluminum. The next stage is the covering of the surface of the front panel with a special mesh for plaster. It is fixed with metal staples. From above the grid becomes covered by glue Ceresit CM-11. It should dry completely.
 Bath Front Panel
 Bath faceplate
Bath faceplate
 Bath faceplate
 Bath faceplate
We lay tiles according to all the rules.For this finishing work you will need a bucket of water, tiles, crosses to level the tiles, a spray bottle to wet the wall and tile adhesive. Another level is required to perform horizontal marking. The tiles begin to be laid from the bottom left corner. After all the work is completed, a special compound is rubbed over the seams. Installation of the revision door is carried out on the same tile glue, additionally still fixed with screws.
 Bath faceplate
 Bath faceplate


Related News


Peltier element is also a thermoelectric module
How to make a St. George ribbon in kanzashi style
Magic pills for sad thoughts
Hairpin Bow
Making a beer keg
Poster by May 9 with your own hands